1972 Norton 750 Commando Rebuild Page 9
I fooled around and got the front wheel and the exhaust installed. Forgot to take some of the pictures, but you get the idea.
I set the initial timing in preperation for installing the electronic ignition.
The rotor for the ignition gets installed into the end of the new camshaft.
This is the stator, or pickup plate, for the ignition.
The ignition wiring comes in through the cases.
This shot shows the stator plate installed. The ignition is now complete.
I sat down for a while and set all the valves. Turned the engine over a few times, and checked and adjusted them again.
This is my new billet custom head steady from Old Britts. It replaced the two rubber cushions that connect the head to the frame.
This is the baseplate mounted on the head.
The complete head steady installed.
